This Schlage Connect lock has the reinforcement plate that goes under the strike place that is anchored by these large reinforcement screws. As you saw the only thing my prior deadbolt had was a strike plate and smaller screws. The reinforcement plate that goes under the strike plate is a major upgrade versus the lock I was using before. The strike plate is actually a bit thicker then my opening so I used my chisel to deepen the opening as well. Attach Reinforcement Plate and Strike Plate for Door Lock The reinforcement plate didn’t fit the current opening either, so I widened it the same way as before using my drill and chisel. I used my chisel to remove a good amount of wood where I found the red lipstickĪfter adjusting the opening, the lock was able to close fully. When I opened the door I could see wherever the red lipstick has transferred and I knew I needed to chisel that section down in order for the lock to be able to close. Then I closed the door and attempted to lock it a few times. I extended the lock out and put the lipstick on the lock wherever I thought it was hitting. I used a trick to fix this, and all I needed was a tube of lipstick and my chisel. When I tested it, the lock didn’t actually go into the hole. Unfortunately when I put the lock in it did not fit like it should. The reinforcement plate for the deadbolt didn’t fit the current opening either so I widened it the same way as before with my drill and chisel. I secured it with the mounting screws and tested the deadbolt fit in my current setup. To expand the recess a little I traced the outline of the plate and chiseled away material until it fit. Right off the bat I had a small fitment issue as the mounting plate was a bit too big. First I started off by removing the old lock and trying to install the Schlage deadbolt in it’s place. The install is pretty similar to most other deadbolts and only requires a screwdriver, a drill and maybe a chisel if you have some fit issues. Remove The Old Lock And Fit New Keyless Door Deadbolt Attach Reinforcement Plate and Strike Plateġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |